Cannot remove toilet tank bolts
Raise the tank back over the bowl housing and reset the central tank gasket and bolts correctly. Re-Install The Toilet Tank And Its Refill. Replace the washers and nut on the second bolt in the same order.Ħ.Add a new metal washer to secure the tank to the toilet bowl housing.Attach a new the bolt nut to the bolt and add the third rubber washer.Put on the second rubber washer on the bolt on the outside of the tank.Insert the bolt into the tank bolt hole.Put one rubber washer on the bolt directly under the bolt head.Attach the new rubber washers following these steps: Replace The Old Washers.Īfter completing the above-mentioned steps, extract the bolts from the toilet tank, making sure that you remove all the old rubber washers. When the tank is heavy, it is best to get someone to help you with lifting the tank straight up and carrying it to the padded surface.
Lift The Tank Off And Set It On a Padded Surface. To make the job easier, you can apply some penetrating oil to loosen the nuts from the bolts and release them from the bowl’s housing.Ĥ. Using an adjustable wrench, loosen the nuts from the bolts, and if they are stuck, you can get a helper to turn the bolts with the screwdriver from inside the tank, while you are holding the nut with the wrench. When you remove the toilet tank lid, set it aside on a pile of towels or blankets and leave room for the tank. You can get rid of the remaining water in the bowl by absorbing it with a sponge or a towel. Empty the bowl completely by flushing the toilet, and using the adjustable wrench, pull clear the water supply line of the tank. Drain The Toilet Tank Of Remaining Water.įirst, you have to make sure you have cut the water supply to the toilet by shut off the valve that is located behind the toilet bowl. Here are steps you can follow to replace these components: 1. This means that you should replace the bolts, and possibly the nuts and washers, given that they are corroded or rusted.
Water leaks on the bolts and nuts, as well as on the floor underneath them, would show you that the toilet tank bolts need new washers. Over time flushing your toilet, its tank bolts might start to leak as the rubber washers used in it would wear out.